THIS IS A PICTURE HEAVY POST!!
After my colouring tutorial on Forever Friends bear, i was asked how i do my Teddy Bo's So i thought i would show you, although this image doesn't have a lot of fur!!
What you will need:
Teddy Bo image (this is one of the new ones released yesterday)
For the FUR
Cocoa
Sandstone
Champagne - Flexmarker
Linen - Flexmarker
IF YOU DON'T HAVE FLEXMARKERS I WOULD USE PUTTY (in place of Champagne) and SATIN (in place of Linen)
For the CHAIR
Shale
Burgundy
Cardinal Red
Ruby
Lipstick Red
Burnt Sienna
Cocoa
Tan
For the BOOT FUR
Cool Grey 1
For the CROWN and CAPE
Egyptian Blue (True Blue)
Colbalt Blue
Artic Blue
CLOTHES
Gold
Buttercup
BOOTS
Raw Sienna
Nutmeg - Flexmarker (cinnamon)
Light Fawn - Flexmarker (ivory)
WORDS IN BRACKETS ARE WHAT I WOULD USE IF I DIDN'T HAVE FLEXMARKERS
Sorry this picture is bright
Go round the edge with SANDSTONE
Now over that with CHAMPAGNE dragging the SANDSTONE out
Then go over the SANDSTONE again
Then again go over with CHAMPAGNE
Now go over it all with LINEN
TWICE
Then with a fine tip attached go round the edge with COCOA
Then over again with LINEN to blend.
Do this until you are satisfied with the colour.
With SHALE go in the darkest area. (don't forget the bit in between the crown)
Then with BURGUNDY go over the SHALE, dragging it out
Now with CARDINAL RED go over the previous 2 colours
Now with RUBY repeating the same technique as before dragging the other colours out
Go over the whole thing with LIPSTICK RED
Use the same method and colours for the trim of the chair and the rope around the bottom.
Now using BURNT SIENNA go around the bottom of the chair
Go over the BURNT SIENNA with COCOA dragging the previous colour out
Now using TAN colour the whole lot.
Using EGYPTIAN BLUE here
Then COBALT BLUE here dragging the EGYPTIAN BLUE out.
Go over it all with ARTIC BLUE (you may need to blend a couple of times)
For the clothes I used GOLD here
Blend with BUTTERCUP leaving a small white area for the highlights or go over it all with IVORY
Onto the boots RAW SIENNA around the edges
Go over the RAW SIENNA with NUTMEG dragging the previous colour out
Go over the whole boot with LIGHT FAWN
Do the same process again but leave out NUTMEG
For the edges of the crown and the 'studs' of the chair i used gel pens
I hope this is of some help!
Pin It
No comments:
Post a Comment